For Steps 1 through 6 take the liner bag and ground sheet out of the box; place the
liner at the center of the ground sheet where you plan to place the pool. Unfold the liner and
note which side of the pump is to be connected to the liner where the thru-the-wall fittings will
be connected. Be careful not to damage the liner when using a knife to open the box. Clear the area
of any sharp objects.
|
For Steps 7 through 12 spread the bottom sleeves on each side of the liner; put one
U-Pipe through each of the bottom sleeve so the open ends of the U-Pipes will be pointed outwards. Fit
the shoes on to the two ends of the U-Pipes. (Follow accordingly)
|
For Steps 13 through 18 spread the bottom sleeves on each side of the liner; put one
U-Pipe through each of the bottom sleeves so that the open ends of the U-Pipes are pointed outwards.
Fit the shoes onto the two ends of the U-Pipes.
|
For Steps 13 through 24, use the longer side of the liner in order to connect pipes
to each other. To make connecting the pipes easier, layout all straight pipes and connect
corner pipes at the end.
|
This Above Ground Pool includes 4 short stem pipes & 4 long stem end-pipes. When
installing the pool, the short stem pipes and long stem end-pipes must be inserted to the corners
of the pool.
|
For Steps 25 through 30, connect the stand-pipes to the frame you’ve already made
above through the liner holes. These two pipes have both male and female ends, so twist the
stand-pipes in order to hold them tight and fixed.
|
After finishing Step 30, you will get an approximate shape of the pool.
Make sure that all connected parts are fixed and well connected. It will be hard to adjust after
filling with water because of water pressure. Install the skimmer, pump and filter, and then fill
the pool with water.
|
